|
The ideal CT Image for radiation therapy treatment planning should have the patient on a flat table, magnification indicators, and density markers.
The Radiation Products Design CT/PET Table Insert is made of 3/8” clear polycarbonate. The insert measures 84” long and the width is custom made to fit the CT or PET Table. A center support runs the length of the insert to prevent any sag.
The CT/PET Table Insert can be made with or without a machine routered lip on each side of the table insert. The machine routered lip fits over the edge of the curved CT bed. The rubber edge table insert is not machine routered and will sit on top of the edges of the curved CT bed.
Optional Magnification and Density Rods
The bottom of the CT/PET Table Insert has two 1/8” (3.2 mm) diameter aluminum rods, spaced 30 cm apart that run the length of the insert and are used for magnification measurements.
A 1” diameter polystyrene rod and a 1” diameter acrylic rod are placed on either side of the center support. Both these rods run 72” along the bottom of the insert. These rods provide a reference for density checks.
Table Density:
Polycarbonate - 1.2 g/cm3
Rod Density:
Acrylic - 1.185 g/cm3
Polystyrene - 1.05 g/cm3
Specifications
Size: 84” L x 3/8” T
Weight: approximately 55 lbs.
Please provide name and phone number of contact person.
When order is placed please specify CT/PET Table Manufacturer and width of CT/PET Table. A cross-section sample of the Table Insert will be sent to customer for verification of proper fit. When proper fit is determined the depth for center support will need to be specified by the customer.
A Dimensions information sheet will be sent to customer prior to manufacturing.
|
