|
• Flattened patient contours for accurate CT planning
• Low density surface for easy autocontouring
• Distance markers for measurement of magnification factor
• Accommodates most indexing systems
• Surface level included
• Designed to fit most CT beds without hardware.
• Optional built-in density reference plugs available in lung, water, and bone equivalent material.
The CT Therapy planning board is a cost effective alternative to more expensive carbon fiber inserts. The board is made in two pieces that nest together. To install simply remove the foam pad from the CT bed and rest the CT planning board on top of the CT bed. When positioned properly, the board will not rock, slip or move during use.
The planning board has two 1mm diameter steel wires which run the length of the bed and are positioned exactly 10 cm apart horizontally and approximately 2 cm below the patient. They provide artifact free markers for quick and easy measurement of magnification on any image.
The top surface of the board includes a peg system to accommodate most immobilization frames.
Note: The electron density plugs are not intended for QA use. For proper QA of the scanner use a CT electron density phantom.
When ordering please specify make of CT Scanner and inside width at the top of the curve.
Material: Expanded PVC Plastic, light weight, rigid and chemical resistant.
Overall Dimensions: 195 cm L x 45 cm W x 7 cm T
Weight: 45 lbs.
|
