View PDF Catalog   

Closeout Items   

30 Gallon Drum and Dolly for Recycling Alloy- 600 lbs Capacity

30 Gallon Drum and Dolly for Recycling Alloy- 600 lbs Capacity
30 Gallon Drum and Dolly for Recycling Alloy- 600 lbs Capacity
Item Number :
879-165

30 Gallon Drum and Dolly for Recycling Alloy- 600 lbs Capacity

Details

30 Gallon Drum and Dolly for Recycling Alloy- 600 lbs Capacity

 

To comply with Federal, State and Local Laws used alloy should be recycled or stored in sealed containers for future disposal.  To properly dispose of alloy, contact your hospital hazardous waste department or your local Pollution Control Agency.  To aid in disposal, Radiation Products Design will accept all alloy.  The 30 Gallon Drum has a handle for easier carrying and includes the lid. 


The included drum dolly was designed to haul up to a 30-gallon drum. Each dolly is capable of moving 1,000 lbs. The 3" caster wheels with integrated ball bearings make moving a fully loaded drum easy. The cross straps on the dolly are designed to prevent sagging or tipping.


Includes:

  • 30 Gallon Drum
  • Drum Lid
  • Drum Dolly

 

Ring Closure Instructions

      1. Place cover on the drum, making sure that the gasket is In place.
      2. Snap the closing ring over the cover and top lip of the drum. Make sure that the ring's lugs point down below the ring. Also, make sure the bottom edge of the closing ring engages under the lip of the drum.
      3. Insert the bolt completely through the lug without threads. Next, screw on the jam nut If Included. Finally, screw the bolt Into the threaded lug.
      4. While tightening the bolt, tap along the entire perimeter of the ring with a mallet, starting directly across from the bolt.
      5. Tighten the bolt according to the manufacturer's recommended torque and gap (listed below). The cover and ring should not spin, and the free ends of the ring should not touch.
      6. If used, tighten the jam nut or lock nut against the lug without threads. This prevents the bolt from backing out of the closing ring.
      7. Label top of drum with either "High Melting Alloy", "Low Melting Alloy", or "Mixed Melting Alloy"
 

Specifications

Weight Capacity: 600 Lbs
Shipping Weight: 41 Lbs

Drum Height: 28 3/4"
Drum Diameter, At Lid (Outside): 19"
Drum Diameter, Opening (Inside): 18"
Drum Material: 18 gauge steel, Rust resistant (not rust proof)
Lid Material: 20 gauge steel, Rust resistant (not rust proof)
Gasket Material: EPDM rubber

 

Dolly Weight: 6.25 Pounds
Dolly Dimensions: 20 x 20 x 6 inches

 

Note:  To dispose of melting alloy, place the used alloy in a sealed container and send it to RPDinc.  RPDinc also recycles alloy, click for details.  THIS IS HAZARDOUS AND TOXIC WASTE; DO NOT THROW IT INTO THE GARBAGE.


Documents

7 other products in the same category: